Expert Plumbing Services in Lansing, Kansas

In the winter, water can freeze in your pipes and cause pipes to break. A leaking pipe can cause flooding and considerable water damage in your space if it’s not mended immediately.

If you have found a leaking pipe, the first step is to shut off your home’s water supply. You’ll complete this at the main water shutoff valve, which is usually located in your utility area or basement. Twisting the valve clockwise will stop the water.

Then reach out to our pros at 913-845-9463 right away. If it’s behind a barrier, in your lawn or under your house’s foundation, we’ll be able to locate the broken pipe and mend it quickly.

If you aren’t using more water than normal and your fee doubles, there’s a good possibility you have a water leak. Sometimes your bill will go up a bit. It’s harder to catch but will generally become more obvious as the leak gets larger.

It may be hard to uncover a water leak without pro assistance. But you can check your water meter to figure out if the leak is inside or outside your home.

A little bit of mildew is usual in hot rooms like bathrooms. But it’s not usual to find large amounts accumulating on a non-shower wall, the ceiling or on baseboards, particularly if these spaces feel soft to the touch.

A dripping pipe can make walls, ceilings and floors to feel soft or sag. It can also leave water spots on surfaces.

These concerns can occur in rooms with poor ventilation or high humidity. But it’s especially difficult if you are encountering other signs of a leaky pipe, like odd fungus-like smells.

Stagnant water can make a space smell like mildew. If the space also has wet walls or floors, you may have a water problem.

Your fittings can back up sewer water and cause damage when the water compression descends in your home. This can be caused by a broken backflow preventer, sewer line deterioration or other city issues. Reach out to us at 913-845-9463 at the first sign of backflow and we’ll get it fixed quickly.

A few things can be going on when your water pressure is low. There may be a block in your plumbing fixture. It could also be caused by a malfunctioning water heater or a broken pipe.

If you possess a hot water unit with a tank, it has a finite capacity for hot water. If you’re getting cold water when you have not used a lot of warm water, something could be wrong. Your boiler could be dripping, malfunctioning or need to be updated.

An obstruction is probably to be the reason when your sink or shower empties too slowly. We use a special instrument like a drain snake to break it up and get your sink and shower draining efficiently again.

If your toilet’s tank seal gets damaged, it will signal the tank to go on refilling. A toilet that continues refilling can rapidly drive up your water bills.

Your water should be see-through.

Don’t worry if it comes out off-color once in a while, as this generally just means there’s air in the water supply. If you find particles settling at the bottom of your glass, you should have your boiler examined.

Water that’s any other color can be dangerous to your health. Here are a few situations that may cause your water to be discolored:

• Brown, red or yellow—This is usually caused by a water main break in your location. It could also mean your pipes are deteriorated.
• Green or blue—This is particularly serious, because it means your pipes are probably corroded. Your water may taste brassy or bitter because of a high amount of copper or lead. Long-term consumption has been linked to serious health challenges in adults and children, including intestinal illnesses, cancer and seizures.

If you’re observing discolored water or sediment in your water, connect with us at 913-845-9463 and we’ll identify the issue.

If your toilet’s tank seal fails, it will signal the tank to continue refilling. A toilet that continues refilling can suddenly drive up your water dues.